INDY HEAT Clean, Economical, High Capacity Heating
Providing heat without the
risk of combustion
Mobile indirect fired heaters are perfect for remote locations where external power is not available and a turnkey heating solution is required. These all-in-one mobile heaters are ready to tow and go to the job site. Ideal for oil wells, wind towers, bridge construction or repair. Use on temporary facilities, tents, and for structural drying in flood/water restoration.
• Fuel options are available.
• Thermostatically controlled for efficiency.
• Separate stainless combustion chamber
• Continuous run time
3,850 lbs. (1,746.33 kg)
5,998 lbs. (2,720.64 kg) (fully fueled)
176 in. (477 cm)
95 in. (241 cm)
89 in. (226 cm)
511 lbs (231.78 kg)
2.3 in. WC
Run up to 100 ft. of duct per heater
Maximum 1,000,000 BTU
Two (2) 500,000 BTU Heaters
Up to 205º F Temp rise
3250 CFM (1-1/2 HP motor)
2- 25AMP circuits, 120 VAC, 60 HTZ
2.5 GPH bruner nozzles per heater,
without generator (at full operation)
5 GPH diesel
7 KW 1,800 RPM diesel, 300 GAL fuel supply
50+ HR. run time under full operation
16 in. discharge duct
Heat up to 1,000,000 BTU's
without the danger of combustion
Unlike direct-fired heaters, Flex-Temp’s Indy Heat provides clean air, free from moisture and contaminated fumes. Indirect-fired heat disburses warm air over large interiors, enclosed structures or vast surface areas. Side panel outlets offer access to duct connections. Work area temps go up quickly and allow projects to move forward. It’s mobility and 1,000,000 BTU heating power takes the cold out of winter weather projects.